Temperature and chemical effects on the interfacial energy between a Ga–In–Sn eutectic liquid alloy and nanoscopic asperities

• Yujin Han,
• Pierre-Marie Thebault,
• Corentin Audes,
• Xuelin Wang,
• Haiwoong Park,
• Jian-Zhong Jiang and
• Arnaud Caron

Beilstein J. Nanotechnol. 2022, 13, 817–827, doi:10.3762/bjnano.13.72

• interfacial energies between a eutectic Ga–In–Sn liquid alloy and single nanoscopic asperities of SiOx, Au, and PtSi have been determined in the temperature range between room temperature and 90 °C by atomic force spectroscopy. For all asperities used here, we find that the interfacial tension of the eutectic

• Ga–In–Sn liquid alloy is smaller than its free surface energy by a factor of two (for SiOx) to eight (for PtSi). Any significant oxide growth upon heating studied was not detected here, and the measured interfacial energies strongly depend on the chemistry of the asperities. We also observe a weak

• increase of the interfacial energy as a function of the temperature, which can be explained by the reactivity between SiOx and Ga and the occurrence of chemical segregation at the liquid alloy surface. Keywords: atomic force microscopy (AFM); interfacial energy; liquid alloy; Introduction Recently, room

Formation of metal/semiconductor Cu–Si composite nanostructures

• Natalya V. Yumozhapova,
• Andrey V. Nomoev,
• Vyacheslav V. Syzrantsev and
• Erzhena C. Khartaeva

Beilstein J. Nanotechnol. 2019, 10, 2497–2504, doi:10.3762/bjnano.10.240

• liquid alloy and 2) core–shell and Janus-like nanoparticles made of liquid silicon and copper droplets. We have presented new data on the formation of metal/semiconductor nanoclusters, such as the transition of particles from a core–shell structure to a Janus-like structure starting from the liquid state

Metal oxide nanostructures: preparation, characterization and functional applications as chemical sensors

• Dario Zappa,
• Angela Bertuna,
• Elisabetta Comini,
• Navpreet Kaur,
• Nicola Poli,
• Veronica Sberveglieri and
• Giorgio Sberveglieri

Beilstein J. Nanotechnol. 2017, 8, 1205–1217, doi:10.3762/bjnano.8.122

• , acting as a catalyst for the synthesis of nanowires. Figure 14 shows the basic mechanism of the evaporation–condensation process including three phases of material. At a certain temperature, the formation of a liquid alloy of metal and catalyst starts by absorbing vapors of the source material. As vapors

Investigation of growth dynamics of carbon nanotubes

• Marianna V. Kharlamova

Beilstein J. Nanotechnol. 2017, 8, 826–856, doi:10.3762/bjnano.8.85

• SiCl4. As soon as the liquid alloy particle was supersaturated, the growth of the whisker started. It occurred by the precipitation of Si atoms from the droplet at the interface between solid Si and liquid alloy. As a result, the alloy droplet was displaced from the Si substrate crystal to the tip of

Review of nanostructured devices for thermoelectric applications

• Giovanni Pennelli

Beilstein J. Nanotechnol. 2014, 5, 1268–1284, doi:10.3762/bjnano.5.141

• (SiH4) flux (or others silicon-based gases). A precise calibration of silane flux and reaction temperature gives a supersaturation of the melt and induces a transformation from the liquid alloy phase to solid Si that crystallizes under the metal nanoparticle. In this way, crystalline silicon

Synthesis and electrical characterization of intrinsic and in situ doped Si nanowires using a novel precursor

• Wolfgang Molnar,
• Alois Lugstein,
• Tomasz Wojcik,
• Peter Pongratz,
• Norbert Auner,
• Christian Bauch and
• Emmerich Bertagnolli

Beilstein J. Nanotechnol. 2012, 3, 564–569, doi:10.3762/bjnano.3.65

• straight, crystalline, nanometre-sized wires. During VLS growth a Si precursor is introduced, which is cracked and dissolved into the catalytic liquid phase. Generally Au is used as the catalyst on Si substrates, forming a liquid alloy with a eutectic temperature of 364 °C, which, upon supersaturation